Week 28

Title: Presentation Day for FYP 2.



Introduction:

During presentation of Development of Staircase Power Generation Using Piezo-Electric is presented to the assessor. Everything working will as expected base on the plan. During the presentation day, all part and connection was explain to the assessor in detailed to make them understanding about my project. All result show as proof that this project done successfully as planning and expected.

Conclusion:

During presentation day, poster and project about Development of Staircase Power Generation Using Piezo-Electric is presented as part to finish the Final Year Project Presentation. After finish the presentation, all student need to concentrate on settle the draft and final report submission as to fulfill the University Kuala Lumpur British Malaysian Institute Requirement.

Week 27

Title: Poster for Presentation

Objective:

1. Completing the poster based on the UniKL guidelines using A1 format.

Method:

1. Design the poster using Microsoft PowerPoint.

Result:

Poster done according to university requirement.

Conclusion:

Basically after finish doing a poster, it show that the project is around the corner to be presented to the assessor. All the detailed is fill in the poster as the reference for the assessor to refer during presentation.

Week 26

Title: Result and Analysis of the Project.

Objective:

1. To get the specific result to achieve the target.
2. Analysis for better development.

Method:

1. Run the prototype and record the output.
2. Measure and count the steps of people steps of the staircase.

Result:

The result shown in the table below.

The output voltage increasing when the number of steps applied to the staircase increase. This shows that the piezoelectric can produce more voltage if more piezoelectric are install inside the staircase. But if the pressure of people steps on it is much higher, it only require less than 50 steps to produce the stabilize output which is between 2.99-3.5V. After that, it will go to step-up voltage to get 12V DC.

Conclusion:

The output is achieve and it meets the target for further applications.